Troubleshooting Terminal, Printer and Serial Device Connections - Edition 4 (32022-90030)

38 Chapter 3

Introduction to TermDSM

Starting TermDSM

To use TermDSM, enter the SYSDIAG command at the MPE/iX prompt

(:). The Diagnostic User Interface prompt appears:

DUI>

From this prompt, many diagnostics can be run. Type HELP to see a list.

To run TermDSM, enter:

DUI>RUN TERMDSM

The following is an example of the type of information that will appear

on the terminal:

***********************************************************

****** TERMDSM ******

****** ******

****** (C) Copyright Hewlett-Packard Co. ******

****** 1987, 1990, 1993 ******

****** ******

****** Version C.00.40 ******

****** ******

****** HP shall not be liable for any damages ******

****** resulting from the use of this program. ******

****** ******

****** Catalog AM.050 ******

***********************************************************

Welcome, Today is FRI, JUNE 11, 1993 at 11:57 AM

Your system has these Datacommunications and Terminal Controllers:

DTC Network

Number Address Name

------ -------- ----

1 08000900180A BIOLAB

2 080009001808 MARKETING

3 080009001234 TIMESHAREROOM

Use this number as the “DTC number” in Termdsm commands.

Comment DIag DTc DUmp EEprom Help Reset Status Trace EXit?