Troubleshooting Terminal, Printer and Serial Device Connections - Edition 4 (32022-90030)

118 Appendix A
TermDSM Messages
MESSAGE: X.25 or X.25/PADSUP not stopped. (TDSM 333)
(TDSM 333) CAUSE: The operation you attempted required that X.25 or
X.25/PADSUP be stopped and it was still running.
ACTION: Start up X.25 on the specified card and try again or specify a
card that has X.25 started.
MESSAGE: DTCM reports unexpected SIC UPLOAD request.
(TDSM 334)
(TDSM 334) CAUSE: Internal error.
ACTION: Contact your HP representative.
MESSAGE: This port is already under extended trace. (TDSM 335)
(TDSM 335) CAUSE: Informational message.
ACTION: Issue the TRACESHOW command to see which ports on the
DTC are currently under extended trace.
MESSAGE: Another port on this MUX is already under extended trace.
(TDSM 336)
(TDSM 336) CAUSE: Only one port on an asynchronous processor board (mux card)
can have extended trace at one time.
ACTION: Turn off extended tracing on a traced port before activating
extended tracing on another port on the same asynchronous processor
board.
MESSAGE: No port on this MUX is under extended trace. (TDSM 337)
(TDSM 337) CAUSE: Informational message.
ACTION: You may issue the TRACEON command to activate extended
tracing on any port on this asynchronous processor board (mux card).
MESSAGE: DTCM reports that DTC reset is not complete yet.
(TDSM 338)
(TDSM 338) CAUSE: A TermDSM command has been issued against a DTC that is
currently undergoing selftest.
ACTION: A DTC selftest may take up to seven minutes. Wait for this
duration before issuing a TermDSM command against the DTC.
MESSAGE: This is not a DTC 72MX, DTC 16iX, or DTC 16MX.
(TDSM 339)
(TDSM 339) CAUSE: A TermDSM command that is only valid for DTC
72MX/16iX/16MX is issued against a DTC 16 or DTC 48.
ACTION: Do not use this TermDSM command on a DTC 16 or DTC 48.