Troubleshooting Terminal, Printer and Serial Device Connections - Edition 4 (32022-90030)

Appendix A 113
TermDSM Messages
ACTION: Contact your HP support representative.
MESSAGE: Bad RMP return code received. (TDSM 261)
(TDSM 261) CAUSE: Unknown error reported by the Distributed Terminal
Subsystem to TermDSM.
ACTION: Contact your HP support representative.
MESSAGE: The DTC subsystem has reported that an error was
detected. Here is the specific message: (TDSM 262)
(TDSM 262) CAUSE: This is the standard message that precedes specific error
messages.
ACTION: Contact your HP support representative.
MESSAGE: An error of unknown type was reported by the DTS
subsystem. (TDSM 263)
(TDSM 263) CAUSE: An error unknown to TermDSM was reported by the
Distributed Terminal Subsystem.
ACTION: Contact your HP support representative.
MESSAGE: The DTC reported an unknown status as a result of the
loopback. Time taken=xx. (TDSM 264)
(TDSM 264) CAUSE: An error unknown to TermDSM was reported by the
Distributed Terminal Subsystem.
ACTION: Contact your HP support representative. You can obtain
additional information by running the card selftest (through the SIC
subcommand of the TermDSM RESET command), the DTC selftest, and
the DTC offline diagnostics.
MESSAGE: Please perform a DTC reset instead of board reset.
(TDSM 266)
(TDSM 266) CAUSE: The DTC 16iX/16MX has only one board; resetting a board is
the same as resetting a DTC.
ACTION: Do a DTC reset instead of a board reset.
MESSAGE: Please perform a DTC upload instead of board upload.
(TDSM 267)
(TDSM 267) CAUSE: The DTC 16iX/16MX has only one board; uploading a board is
the same as uploading a DTC.
ACTION: Do a DTC upload instead of a board upload.
MESSAGE: You have entered an incorrect ROM code version.)
(TDSM 268) CAUSE: Incorrect ROM code version was entered for EEPROM
reprogramming.
ACTION: Re-enter the correct ROM code version.