Troubleshooting Terminal, Printer and Serial Device Connections - Edition 4 (32022-90030)

110 Appendix A
TermDSM Messages
ACTION: Reconnect the modem and try the test again. If the failure
continues, or if there was no modem in use on that port, there is a
probable hardware failure.
Contact your HP support representative. You can obtain additional
information by running the card selftest (through the SIC subcommand
of the TermDSM RESET command), the DTC selftest, and the DTC
offline diagnostics.
MESSAGE: Console attention. Time = xx msec. (TDSM 234)
(TDSM 234) CAUSE: Probable hardware failure.
ACTION: Contact you HP support representative. You can obtain
additional information by running the card selftest (through the SIC
subcommand of the TermDSM RESET command), the DTC selftest, and
the DTC offline diagnostics.
MESSAGE: Operation aborted. (TDSM 235)
(TDSM 235) CAUSE: The operation was aborted by the DTC. Possibly, the download
file is invalid.
ACTION: Verify the version and integrity of the download file. Contact
your HP support representative. You can obtain additional information
by running the DTC selftest DTC selftest or the DTC offline diagnostic.
MESSAGE: During a DTC reset/dump request from the mainframe.
(TDSM 240)
(TDSM 240) CAUSE: Informational message which can be printed after an error
message. It describes in which phase of an operation the error occurred.
ACTION: Refer to the cause and action descriptions for the actual error
message preceding message 240.
MESSAGE: During the DTC download operation. (TDSM 241)
(TDSM 241) CAUSE: Informational message which may be printed after an error
message. It describes in which phase of an operation the error occurred.
ACTION: Refer to the cause and action descriptions for the actual error
message preceding message 241.
MESSAGE: During a DTC upload (dump) operation. (TDSM 242)
(TDSM 242) CAUSE: Informational message which may be printed after an error
message. It describes in which phase of an operation the error occurred.
ACTION: Refer to the cause and action descriptions for the actual error
message preceding message 242.
MESSAGE: Bad parameter from TermDSM. (TDSM 243)
(TDSM 243) CAUSE: Internal error.
ACTION: Contact your HP support representative.