Troubleshooting Terminal, Printer and Serial Device Connections - Edition 4 (32022-90030)

Appendix A 105
TermDSM Messages
MESSAGE: You can’t reset your own port or ldev. Please run
TermDSM from a different port or ldev to do this. (TDSM 80)
(TDSM 80) CAUSE: Verify the ldev numbers entered. If you want to reset a port,
you cannot be logged on to that port; the operation will abort your
session.
ACTION: If you want to reset the port you are using, move to another
port or the system console to run TermDSM.
MESSAGE: That ldev is unknown (not configured). Please check the
ldev number, or use reset port. (TDSM 81)
(TDSM 81) CAUSE: Although a number was entered in a range that could be an
ldev number, that number is not configured on the system.
ACTION: Verify the ldev number by entering the SHOWJOB command.
You can also reset ports by using the POrt subcommand (which uses
the physical address instead of the ldev number).
MESSAGE: You must have high (1) or medium (2) security to do
resets, and high (1) security to reset DTCs. (TDSM 82)
For level 1, you need SM or DI capability.
For level 2, you need SM or DI or OP capability.
(TDSM 82) CAUSE: You do not have the correct user capabilities to do this function.
ACTION: Logon as a user with the correct capabilities for the functions
you wish to use. Refer to Chapter 4, “TermDSM Commands,” for the
security level of each command and subcommand.
MESSAGE: You must have high (1) or medium (2) security to test
ports, and high (1) security to selftest DTCs. (TDSM 82)
For level 1, you need SM or DI capability.
For level 2, you need SM or DI or OP capability.
(TDSM 86) CAUSE: You do not have the correct user capabilities to do this function.
ACTION: Logon as a user with the correct capabilities for the functions
you wish to use. Refer to Chapter 4, “TermDSM Commands,” for the
security level of each command and subcommand.
MESSAGE: TermDSM could not open the DTC manager, so the DTC
dump could not be obtained. (TDSM 93)
(TDSM 93) CAUSE: Internal error, unless another TermDSM was being run against
that same DTC and you chose not to override the other user. There is no
error in this case.
ACTION: Contact your HP support representative (if it is an internal
error).