Troubleshooting Terminal, Printer and Serial Device Connections - Edition 4 (32022-90030)

102 Appendix A
TermDSM Messages
The override facility is provided for the case where a terminal running
TermDSM is hung and therefore cannot exit the program. Note that if
one TermDSM user resets the port of another TermDSM user, this can
cause the system to go down.
MESSAGE: No ldevs seem to be configured on your system.
(TDSM 36)
(TDSM 36) CAUSE: Necessary configuration information does not exist on the
system.
ACTION: Make sure the file NMCONFIG.PUB.SYS exists. Bring the
system down and back up again, making sure that the proper SYSGEN
files are used. (The SYSGEN files used are determined by the boot path.
The file NMCONFIG.PUB.SYS is used automatically.) If the problem
persists, contact your HP support representative.
MESSAGE: The dump process can't find out the length of the data
area. (TDSM 37)
(TDSM 37) CAUSE: Internal error.
ACTION: Contact your HP support representative.
MESSAGE: The data area is longer than TermDSM's dump buffer.
(TDSM 38)
(TDSM 38) CAUSE: Internal error.
ACTION: Contact your HP support representative.
MESSAGE: TermDSM never received a reply to its dump data area
request. (TDSM 39)
(TDSM 39) CAUSE: Internal error.
ACTION: Contact your HP support representative.
MESSAGE: You must have high (1) security to perform this function.
(TDSM 42)
For level 1, you need SM or DI capability.
(TDSM 42) CAUSE: You do not have the correct user capabilities to use this
function.
ACTION: Logon as a user with the correct capabilities for the TermDSM
functions you wish to use. Refer to Chapter 4, “TermDSM Commands,”
for the security levels of each command and subcommand.
MESSAGE: You can’t do this from your own DTC. Please run
TermDSM from another DTC or from the console. (TDSM 43)
(TDSM 43) CAUSE: If you were permitted to selftest, dump, or reset the DTC to
which you are logged on, your session would be aborted and you would
be unable to get the test results.