Troubleshooting Terminal, Printer and Serial Device Connections - Edition 4 (32022-90030)

100 Appendix A
TermDSM Messages
ACTION: Enter a valid ldev number. Note that you can also use the
POrt subcommand.
MESSAGE: The ldev number is missing or invalid. Ldev numbers are
positive integers. (TDSM 21)
(TDSM 21) CAUSE: The logical device number was not entered or is
unrecognizable.
ACTION: Enter a valid ldev number. Note that you can also use the
POrt subcommand.
MESSAGE: You have entered an invalid SIC card number. SIC card
numbers range from 0 to 5. (TDSM 22)
(TDSM 22) CAUSE: The card number that you entered is not in the range from zero
to five. Card number range from 0 to 1 for DTC 16, 1 for DTC
16iX/16MX, from 0 to 5 for DTC 48, and from 0 to 3 for DTC 72MX.
ACTION: Double check the card numbers by looking at the back of the
DTC. Enter the card number again.
MESSAGE: The SIC card number is missing or invalid. SIC card
numbers range from 0 to 5. (TDSM 23)
(TDSM 23) CAUSE: The card number was not entered or is unrecognizable.
ACTION: Enter the card number again. Refer to the prompt or Chapter
4, “TermDSM Commands,” for syntax.
MESSAGE: You have entered an incorrect DTC number. Please
choose a “DTC number” from this list. (TDSM 24)
(TDSM 24) CAUSE: The value entered does not correspond with any DTC on the
system.
ACTION: The DTCs on the system are listed with their numbers. Enter
one of the numbers displayed.
MESSAGE: The DTC number is missing or invalid. Please choose a
DTC number from this list. (TDSM 25)
(TDSM 25) CAUSE: The DTC number was not entered or is unrecognizable.
ACTION: The DTCs on the system are listed with their numbers. Enter
one of the numbers displayed.
MESSAGE: TermDSM cannot do the dump because there are already
too many dump files. Please purge some. Dump files are of the form
TRMnnnaa.PUB.SYS. where nnn is a 3 digit number and aa is 2
alphabetic characters. (TDSM 27)
(TDSM 27) CAUSE: The dump files TRMdddAA through TRMdddZZ already exist. (The
sequence ddd is the current Julian date.)