System Debug Reference Manual (32650-90888)

344 Chapter9
System Debug Window Commands
wM
w M
Window mode. Changes the mode for the Q or S window.
Syntax
QM [ addressmode ] [ signed ]
SM [ addressmode ] [ signed ]
Parameters
addressmode This parameter specifies the mode in which addresses are to be
displayed. If no value is specified, DB is the default. The following values
are allowed:
DB Display address as DB-relative values (initial mode).
DL Display address as DL-relative values.
DST Display address as DST-base-relative values.
Q Display address as Q-relative values.
S Display address as S-relative values.
If the window is jumped to a data segment other than the stack data
segment (SDST), only DST mode is allowed.
Addresses entered with the QJ and SJ commands are interpreted based on
the mode of the respective window.
signed This parameter indicates if addresses are to be displayed as signed or
unsigned values. If no value is specified, UNSIGNED is the default.
The following values are allowed:
UNSIGNED Display address as unsigned values (initial setting).
SIGNED Display address as signed values (+/- present in address).
Examples
$nmdebug > qm dst
Set the Q window to display addresses as DST-relative (stack-base relative) values.
$nmdebug > sm ,signed
Set the S window to have addresses displayed as signed values.
Limitations, Restrictions
none