Standalone Logtool for MPE/iX

The memory error log file contains memory error information gathered by the memory error logging process
(MEMLOGP). The MEMRPT command will produce a summary report based on the information from the memory log
file. The MEMCLR command will give the user the ability to clear all the information in the memory log file. In addition,
the MEMTIMER command allows the user to change the time interval in which the MEMLOGP process will scan all the
memory controllers to see if any memory errors occurred.
In addition to the various log file commands, LOGTOOL contains commands which aid the user during a LOGTOOL
session.
HELP Displays detailed and syntax summary information to the user upon request.
REDO Allows the user to edit/recycle previous input.
SUSPEND Allows the user to temporarily suspend
LOGTOOL and return control to the Diagnostic User Interface
(DUI).
Defects and Enhancements
Submit defect reports and enhancement requests concerning this diagnostic through the STARS database referencing
product number 30600-10019.
Minimum Configuration
The System and Memory Log Analysis Tool (LOGTOOL) executes on any HP Precision Architecture RISC computer up
and running on the MPE/iX 6.5 or later operating systems.
Operating Instructions
Starting LOGTOOL
To start logtool, log in to a computer system running MPE/iX 6.5 or higher. Enter the following command:
MPE_PROMPT> LOGTOOL
|
no parameters required to load
Test Execution
When executed, the utility displays a header and welcome message:
HPDST240-BICKLE->PUB.SYS#logtool
*******************************************************************
****** ******
****** LOGTOOL ******
****** ******
****** (C) Copyright Hewlett Packard Co. ******
****** 1989,1990,1991,1992,1993,1994,1995,1999 ******
****** All Rights Reserved. ******
****** ******
****** HP shall not be liable for any damages resulting ******
****** from the use of this program. ******
****** ******
****** Version A.03.05 ******
****** ******