SNA NRJE User/Programmer Reference Manual (30292-90006)

Chapter 3 91
User Commands
SUBMIT
DIRECT
When you use this parameter, translation and
compression will be done during transmission to the
host.
You cannot use (NOTRANSLATE) and DIRECT together.
n
Identifies a spool file transmission queue priority
number. The highest priority is 14, and the lowest is 1.
Job transmission to the host can be deferred by
specifying a priority value less than or equal to the
reader fence value, RDRFENCE, for a workstation. If
RDRFENCE=0, then OUTFENCE, an MPE parameter, is
used to select job spool files for transmission to the
host. The configuration of RDRFENCE is described in the
SNA NRJE Node Manager’s Guide.
If you omit this parameter, the MPE-configured default
is used.
Name
Identifies a job when it is in a transmission queue. You
can use this
Name in subsequent NRJE commands.
A
Name must begin with a letter and may contain up to
eight alphanumeric characters.
If you give several jobs the same Name , then other
NRJE commands, such as SHOW, can refer to all job files
with that
Name .
If you omit this parameter, the job you submit and
output from the job are assigned the name specified in
the JCL JOB card.
Wsid
Identifies an alternate NRJE workstation on your node
to which this command applies. The job will be
submitted to the reader in the specified alternate
workstation.
You normally omit this parameter and submit jobs to
the workstation you identified in the NRJE command.
This parameter does not alter the default workstation
for subsequent commands.
PrintFile
Used to specify routing for output data sets that are
sent to an NRJE logical printer on the standard form.