SNA NRJE User/Programmer Reference Manual (30292-90006)

56 Chapter3
User Commands
User Commands
User Commands
This subsection describes each NRJE subsystem command available to
a user. Some user command parameters are available only to NRJE
managers. Those are described in this section, also. NRJE manager
commands are described in the SNA NRJE Node Manager’s Guide.
Users who do not have NM capability can access the remote console
facility, provided one or more commands have been “allowed” by their
node manager. Once in the console facility, all users remain there
indefinitely until either the workstation terminates or the user issues
the RELEASE command to exit the console. If the workstation
terminates, the RELEASE command is executed automatically for the
user.
The user commands discussed in this section are shown in Table 3-1.
Table 3-1 NRJE User Commands
Command Description
ALTER *
Changes the priority of a submitted job or jobs.
CANCEL *
Purges jobs awaiting transmission. Deletes returning output data sets for
jobs already transmitted to the host.
If you are connected to a VSE/POWER host system, only jobs awaiting
transmission are cancelled.
CONSOLE
Obtains access to the host remote console of a workstation.
DISPLAY
Provides display of workstation and workstation-related information.
EXIT
Causes the user to exit from the NRJE command interpreter (CI) and
returns control to the process from which the CI was run.
##FD
Used within a job to include the contents of a file.
HELP
Provides you with information about subsystem commands.
NRJE
Invokes the subsystem command interpreter. It is also an NRJE
subsystem command and allows you to switch to a different default
workstation.
REDO
Allows you to modify and/or execute the previous NRJE subsystem
command. Use this like the MPE
REDO command.
RELEASE
Relinquishes access to the host remote console of a workstation.
REMARK
Provides a way to do in-line comments when you use NRJE subsystem
commands in an HP 3000 job.
RUN
Executes a prepared program.