SNA NRJE User/Programmer Reference Manual (30292-90006)

52 Chapter3

User Commands

Introduction

Some user commands have NRJE manager extensions. You must be

conﬁgured with NM capability to use them.

Job Output

Output from a job is automatically received from a host whenever

communication is established between a workstation and a host. You do

not need to issue an NRJE subsystem command or related intrinsic to

receive your job output.

Job output can be directed to any output device that is supported by

your HP 3000. These include laser printers, line printers, and disk and

tape ﬁles. These devices can be spooled or non-spooled, but the default

output device for your workstation, as conﬁgured in the NMMGR

Workstation Data Page 2 screen, must be spooled. Control of the ﬁnal

destination can be determined either at the time your job is submitted

for transmission to the host, or after the output has been returned from

the host. Chapter 4 , “Job Output,” describes job output, including the

following:

• How to route job output.

• The relationship between SNA control codes and HP 3000 carriage

controls.

• The JCL to use for special forms processing.

• Directing output to an HP 268XX laser printer.

• How to relate host output classes and message classes (msgclass)

with logical writers by using JCL and host job entry subsystem

commands.