SNA NRJE User/Programmer Reference Manual (30292-90006)
Chapter 2 47
Getting Started
NRJE Shutdown
Use of NRJEJCW
The following example can be used to restart NRJE after the host
system disconnects:
!JOB NRJE,MANAGER>>SYS/
password
,NRJE;OUTCLASS=,1
!RUN NRJEMON;INFO=
"wsid"
!IF NRJEJCW = 1224 OR NRJEJCW = 3005 THEN
! CONTINUE << Received unbind or hierarchical shutdown >>
! SNACONTROL START;NODE=
nodename
! NRJECONTROL START;WSID=wsid
!ENDIF
!EOJ
The example below includes SNACONTROL commands, which are the
responsibility of the SNA node manager and are described in the SNA
Link Services Reference Manual or the SNA Link/XL Node Manager’s
Guide.
In this example, the input entered by the NRJE manager is shown in
the first column, and instructions and explanations are in the other
columns.
Example
Issue a status command before the SNA node
is started.
:snacontrol status;node=ibmnode
NODE SPECIFIED NOT ACTIVE. (SNACIERR 9)
Start the SNA node.
:snacontrol start;node=ibmnode
SNA TRANSPORT VERSION: A.XX.XX
Enter the NRJE subsystem.
:nrje r20
product number version number
NRJE (C) HEWLETT-PACKARD CO
copyright year
WELCOME TO NRJE
Issue DISPLAY INFO command.
R20>display;info
Workstation: R20
GENERAL INFORMATION
State: INACTIVE The workstation is INACTIVE
Jes: JES2 even though the SNA node has
Remote: RMT20 been started.
Host command prefix char: $
Allowed console commands:
Formid lookup table: NRJETABL.NRJE
Default print form name: STD