SNA NRJE User/Programmer Reference Manual (30292-90006)

130 Chapter5
User Intrinsics
Introduction
Introduction
All of these intrinsics are related to NRJE commands described in
Chapter 3 , “User Commands.” The manager extensions to the
commands are also indicated in this chapter.
NRJE consists of a subsystem command interface and a set of
user-callable intrinsics. An NRJE intrinsic, or a set of intrinsics,
corresponds with each subsystem command that affects job stream
input or output.
NRJE intrinsics can be called from:
• SPL
• PASCAL
• FORTRAN
• COBOL II
If you omit any parameters, you must retain the commas that follow
them. No variable length calling sequences exist.
Byte array parameters with the left-most character blank indicate that
a default value will be used.
Split-stack mode intrinsic calls are prohibited.
See Table 5-1, “NRJE User Intrinsics” for a summary. Some user
intrinsics have capabilities that can be used by NRJE managers only.
NRJE intrinsics that can be used only by NRJE managers are described
in Chapter 6 , “NRJE Manager Intrinsics.”