SNA NRJE Node Managers Guide (30292-90007)

46 Chapter3
SNA NRJE Configuration
Configuring SNA NRJE
back-referenced to the ldev number of the INP or the
system disk. Set the record width to 40 words; set the
unit, channel, and output device to 0. Specify driver
IONRDR0.
Chain Size
Required. The maximum number of RUs that NRJE
will transmit before requiring a definite response from
the host. You can get higher throughput with larger
values, but if line trouble occurs, the data might have to
be retransmitted from the beginning of the chain. Also,
if you are using only a few LUs, specifying a larger
value here might impact remote console response time.
Range: 1 – 99 (integer)
Default: 10
Translation Indicator
Required. The type of translation NRJE will perform
on jobs sent to the host:
• 0 = Native – 3000 translation
Input in the Native–3000 language (ASCII) is
translated to EBCDIC before it is sent to the host.
• 1 – 255 = Native Language ID
An integer that corresponds to 8-bit languages other
than Native–3000. Input in the language chosen is
translated to EBCDIC before it is sent to the host.
Invalid values are:
201 Simplified Chinese
211 Traditional Chinese
221 Japanese
231 Korean
For more information on Native Language Support,
see the Native Language, Message Catalogs, and
User Logging manual.
Default: 0
Number of Readers
Required. The number of logical host readers that the
NRJE remote workstation will use. (Also see the LU
Data screen description earlier in this chapter.)
Range: 1 – 7
Default (JES2 and JES3): 1