SNA NRJE Node Managers Guide (30292-90007)

232 AppendixA
Result Codes and Messages
SNA NRJE Logging Messages
file to a new format by running the Node Management Services
conversion utility NMMGRVER.
9002 MESSAGE: NRJE(!:!): WARNING: COULD NOT LOAD CONSOLE EXIT
PROCEDURE. INTERNAL DECODE ROUTINE WILL BE USED. (LOAD
ERR=!) (LU=9002)
CAUSE: NRJE encountered a loadproc error while attempting to load
the console exit procedure.
ACTION: Ensure that the procedure name in the Workstation Data
screen is correct and that the procedure exists in SL.NRJE.SYS or
SL.PUB.SYS. Ensure that the RUN command of the NRJE Stream file
runs the NRJEMON program with “LIB=G”.
9003 MESSAGE: NRJE(!:!): FAILED TO LOCK LU’DUMP’RIN. (LU=9003)
CAUSE: Internal software error. Logged only while aborting due to a
more serious error.
ACTION: None.
9004 MESSAGE: NRJE(!:!): FAILURE TO OPEN JOBLOG FILE (LU=9004)
CAUSE: An FOPEN error occurred on the Joblog file.
ACTION: Check the preceding error message which will identify the
nature of the fopen failure. Ensure that Workstation Data screen
correctly identifies the name of the Joblog in the NRJE group of the
SYS account. Ensure that all NRJE module versions are compatible.
9005 MESSAGE: NRJE(!:!): FAILED TO WRITE TO NRJE XDS (XDS=!)
(LU=9005)
CAUSE: Access error occurred while attempting to save the Joblog
record length value in the NRJE XDS. An internal software error.
ACTION: Contact Hewlett-Packard for assistance.
9006 MESSAGE: NRJE(!:!): FAILED TO OPEN JOB, TEMP COPY OF
LOOKUP TABLE (FSERR=!) (LU=9006)
CAUSE: FOPEN failure on the internal job temporary copy of the
Lookup Table.
ACTION: Ensure that NRJE versions are correct. If versions are
compatible, contact Hewlett-Packard for assistance.
9007 MESSAGE: NRJE(!:!): FAILED TO ACQUIRE FORMID XDS (LU=9007)
CAUSE: A GETDSEG failure was encountered.
ACTION: Ensure that NRJE versions are compatible. Ensure that the
system configuration for “MAXIMUM NUMBER OF EXTRA DATA
SEGMENTS/PROCESS” is greater than 4.