SNA NRJE Node Managers Guide (30292-90007)

Appendix A 191
Result Codes and Messages
SNA NRJE Error Messages
ACTION: Correct the command or parameter and re-enter the data.
723 MESSAGE: KEYWORD VALID ONLY IN SOME OF THE OPERATOR
COMMANDS. (CI=723)
CAUSE: A keyword has been entered and is not valid for the current
command.
ACTION: Refer to NRJE manual for command syntax and reenter.
724 MESSAGE: UNABLE TO PARSE THE PARAMETER LIST. (CI=724)
CAUSE: A syntax error has occurred in the parameter list.
ACTION: Correct the information and re-enter the data.
725 MESSAGE: SEMICOLON IS EXPECTED. (CI=725)
CAUSE: A semicolon was omitted.
ACTION: Correct the information and re-enter.
726 MESSAGE: KEYWORD CAN BE SPECIFIED ONLY IN THE STARTWS
COMMAND. (CI=726)
CAUSE: A keyword was used incorrectly.
ACTION: Omit the keyword from the command and re-enter the data.
727 MESSAGE: UNABLE TO OPEN $STDINX. (CI=727)
CAUSE: The $STDINX input file could not be opened.
ACTION: Another routine may be using $STDINX. Wait and then try to
open again.
728 MESSAGE: UNABLE TO OPEN $STDLIST. (CI=728)
CAUSE: The $STDLIST output file could not be opened.
ACTION: Another routine may be using $STDLIST. Wait and then try to
open again.
729 MESSAGE: KEYWORD CAN BE SPECIFIED ONLY IN THE SUBMIT
COMMAND. (CI=729)
CAUSE: The keyword use is limited to the SUBMIT command.
ACTION: Delete the keyword from this command and re-enter the data.
730 MESSAGE: WARNING: ATTEMPT TO SWITCH TO THE CURRENT
WORKSTATION. (CI=730)
CAUSE: The current workstation and the new workstation are identical.
ACTION: Switching workstation is superfluous.
731 MESSAGE: MORE PARAMETERS ARE EXPECTED. (CI=731)
CAUSE: There are too few parameters.