SNA NRJE Node Managers Guide (30292-90007)

Appendix A 161
Result Codes and Messages
SNA NRJE Error Messages
231 MESSAGE: UNABLE TO TEST-OPEN PRINT DESTINATION FILE.
(INT=231)
CAUSE: SUBMIT and NRJE2Submit test most output destinations (by
opening them) to be sure they’re there. A file system related error. A file
system error message will follow.
ACTION: Determine the cause by inspecting the file system error
message and correct the problem.
232 MESSAGE: UNABLE TO TEST-OPEN PUNCH DESTINATION FILE.
(INT=232)
CAUSE: SUBMIT and NRJE2Submit test most output destinations (by
opening them) to be sure they’re there. A file system related error. A file
system error message will follow.
ACTION: Determine the cause by inspecting the file system error
message and correct the problem.
233 MESSAGE: UNABLE TO TEST-OPEN FORMS DESTINATION FILE.
(INT=233)
CAUSE: SUBMIT and NRJE2Submit test most output destinations (by
opening them) to be sure they’re there. A file system related error. A file
system error message will follow.
ACTION: Determine the cause by inspecting the file system error
message and correct the problem.
234 MESSAGE: UNABLE TO CLOSE JOB SPOOL FILE DURING ERROR
CLEANUP. (INT=234)
CAUSE: While trying to clean up from a previous file system error in
preparation for an error return, SUBMIT or NRJE2Submit was unable to
close the currently open output spool file. Any file system error message
following this message refers not to this error but to the original file
system error.
ACTION: Exit NRJE to close the spool file. Then use SPOOK (or NRJE)
to delete it. Report problems of this nature to your HP representative.
235 MESSAGE: COMPACTION OF INPUT FILES IS NOT SUPPORTED.
INPUT FILE #!. (INT=235)
CAUSE: A compaction SCB was found in the input file specified or one of
its ##FD include files.
ACTION: See “Problem Resolution” in Chapter 5 , “SNA NRJE
Troubleshooting,” of this manual, and contact your HP representative
for assistance.