SNA NRJE Node Managers Guide (30292-90007)

Appendix A 155
Result Codes and Messages
SNA NRJE Error Messages
195 MESSAGE: PR & PU OUTPUT DESTINATIONS EXCEED MAX WIDTH.
(INT=195)
CAUSE: The job log can only handle a total of 214 characters of output
destination information. The PR and PU destinations, together, are too
long. Note: file names are fully qualified by SUBMIT before they end up
in the job log, and backreferences are expanded to the original file
equation.
ACTION: Correct the problem.
196 MESSAGE: PR, PU, & FO OUTPUT DESTINATIONS EXCEED MAX
WIDTH. (INT=196)
CAUSE: The job log can only handle a total of 214 characters of output
destination information. The PR, PU, and FO destinations, together, are
too long. Note: file names are fully qualified by SUBMIT before they end
up in the job log, and back references are expanded to the original file
equation).
ACTION: Correct the problem.
197 MESSAGE: DISALLOWED CONSOLE COMMAND STRIPPED FROM
JOB STREAM. (INT=197)
CAUSE: Users without NM capability are allowed to insert in a job
stream only those host commands specified in the configuration file.
ACTION: No action is required.
198 MESSAGE: UNABLE TO READ FROM CONSOLE TEMP FILE. INPUT
FILE #!. (INT=198)
CAUSE: A file system error has occurred. A file system error message
will follow.
ACTION: Determine the cause by inspecting the file system error
message and correct the problem.
CAUSE: A severe error has occurred.
ACTION: See “Problem Resolution” in Chapter 5 , “SNA NRJE
Troubleshooting,” of this manual, and contact your HP representative
for assistance.
199 MESSAGE: UNABLE TO WRITE CONSOLE DATA TO SPOOLFILE.
INPUT FILE #!. (INT=199)
CAUSE: A file system error has occurred. A file system error message
will follow.
ACTION: See “Problem Resolution” in Chapter 5 , “SNA NRJE
Troubleshooting,” of this manual, and contact your HP representative
for assistance.