SNA NRJE Node Managers Guide (30292-90007)

134 AppendixA
Result Codes and Messages
Validation Messages
NRJEVALERR 9 MESSAGE: Path: !
Logical device “!” is not a valid NRJE reader. (NRJEVALERR 9)
CAUSE: The indicated ldev is invalid for the reader indicated in the
path. This usually happens when the ldev is already configured for
another subsystem.
ACTION: Configure the correct ldev for the reader in the Logical
Device field of the NRJE Configuration: Reader Data screen.
Remember that you should not configure the same reader ldev for
workstations that might be simultaneously active.
NRJEVALERR 10 MESSAGE: Path: !
Lookup table is not configured under PAGE2 screen.
(NRJEVALERR 10)
CAUSE: A formid is configured in the Output Destination field of the
NRJE Configuration: Writer Data screen, but a lookup table is not
configured in the Formid Lookup Table File field of the NRJE
Configuration: Workstation Data Page 2 screen.
ACTION: If you want a lookup table to be used, ensure that a table is
correctly configured on the NRJE Configuration: Workstation Data
Page 2 screen. If you do not want a lookup table to be used, ensure that
a formid is not configured on the NRJE Configuration: Writer Data
screen.
NRJEVALWARN
11
MESSAGE: Path: !
LUs not validated. Invalid SNAnode “!”. (NRJEVALWARN 11)
CAUSE: This error is related to NRJEVALERR 8. If an invalid node name
is specified on the NRJE Configuration: Workstation Data screen, the
LUs cannot be validated. Note that this is a warning message.
ACTION: Ensure that the indicated SNA node name is correct. If it is,
contact your HP representative.
NRJEVALERR 12 MESSAGE: Path: !
LU “!” is not configured for SNAnode “!”. (NRJEVALERR 12)
CAUSE: The indicated LU is not configured under the indicated SNA
node.
ACTION: Ensure that the LU should be configured under the SNA node.
If it should be configured, configure it on the SNA Configuration: PU
and LU Data screen.
NRJEVALERR 13 MESSAGE: Path: !
No writers are configured. (NRJEVALERR 13)
CAUSE: No writer is configured for the workstation indicated in the
path.
ACTION: Configure at least one writer for the workstation on the NRJE
Configuration: Writer List screen.