SNA NRJE Node Managers Guide (30292-90007)

122 Chapter6
Commands
TRACEON
TRACEON
Turns on intrinsic and/or LU tracing for a workstation.
Syntax
TRACEON[;W[SID]= Wsid ]
[;TR[ACE]= Type [, Type ][, File ][, Size ]]
Parameters
Wsid The workstation name. This can be up to eight
alphanumeric characters long; the first character must
be alphabetic.
If you omit this parameter, the default workstation
identifier is used. You can specify a default workstation
identifier in the NRJE command.
Type The type of trace to be started:
• LU: for NRJE LU procedures.
• INTRINSIC: for commands and intrinsics accessed
by NRJE workstation users and managers. These
intrinsics are traced:
NRJEAlter NRJELUList NRJEStopWS
NRJECancel NRJELUStatus NRJESubmit
NRJEConsole NRJEQueue NRJE2Submit
NRJEHJCancel NRJERdrAccess NRJETrace
NRJEHJInfo NRJERdrFence NRJEWriter
NRJEJobInfo NRJEStartWS NRJEWSInfo
NOTE Use this option only when recommended by your HP representative.
This type of tracing can have a performance impact.
LU tracing for a workstation can be initially started only when the
workstation is started. After that, it can be started and stopped at any
time, as long as the workstation is active.
File An actual file designator of a disk file used for trace
output data.
If you do not specify the name of a trace output file, the
default file name NMTC
nnnn .PUB.SYS is used, where
nnnn is a number from 0000 through 9999. The nnnn
integer is incremented to form and find the next
available trace file name. You can always retain trace
data by using a default file name; however, considerable
disk space might be used.