SNA Link/iX Node Managers Guide (30291-90009)

88 Chapter3
Logging Configuration
Configuring Logging
• CLAS0013: diagnostic messages
— Internal data
NOTE If you want the logging events for only a specific logging subsystem and
class to be displayed at the list devices of users, see “Enabling Users for
a Specific Subsystem and Class” later in this chapter.
File
For display only. The name of the configuration file.
Once you have entered all of the logging information,
press
[f6] (Save Data).
Then, if you do not want to configure logging
information for other SNA subsystems, press [f5]
(Validate HP-IBM) to validate the logging
configuration you just did. Once the logging
configuration is validated, press
[f4] (Exit Logging) to
return to the “HP-IBM Configuration” screen.
If you want to configure logging information for other
SNA subsystems, (1) press
[f1] (Next Screen) once,
which places you at the “IBM Logging Configuration
(2)” screen (described next in this chapter); or (2) press
[f1] (Next Screen) twice, which places you at the “IBM
Logging Configuration (3)” screen (described later in
this chapter).
IBM Logging Configuration (2) Screen
On this screen (Figure 3-4), you specify logging information for these
subsystems: APPC, link trace, and SDLC link.
If you want to specify logging information for an SNA subsystem not
shown on this screen, press
[f1] (Next Screen), which places you at the
“IBM Logging Configuration (3)” screen (described later in this
chapter), or press
[f8] (Prior Screen), which places you at the “IBM
Logging Configuration (1)” screen (described earlier in this chapter).