SNA Link/iX Node Managers Guide (30291-90009)

Chapter 2 71
SNA Node and Link Configuration
Configuring the SNA Node and Link
of the “X.25 PVC Address Key Paths”
screen), that address key must match
the value specified in this field. See
Figure 2-7 for an example.
DTC Manager Configuration: The
range specified for the LCI Range field
(for PVCs) of the “DTC Manager
DTCX25 Board # Level 3” screen must
contain the value specified in this field.
DTS Configuration: The range specified
for the LCI Range field (for PVCs) of
the “DTS X.25 Card Config — Level 3
&Miscellaneous” screen must contain
the value specified in this field.
SVC DATA
Information about the switched virtual circuit (SVC).
Remote’s X.25 Network Address
Conditionally required. The X.25 network address of
the remote system. This is found in the X.25 network
subscription information.
This field is required
only if SVC is entered for the
Virtual Circuit Type field.
Host Configuration: If the host is configured to make
outgoing calls, the DIALNO operand value of the PATH
macro that defines the dial-out path to the HP 3000
node must contain the value specified in this field; see
Table 2-3. For security purposes, SNA/X.25 Link
compares the remote X.25 address contained in
incoming calls with the value specified in this field. See
the HP SNA Products Remote System Configuration
Guide for more information about host configuration.
Also, the features and names of the facility sets are
found in the X.25 network subscription information.
Note that the facility set (the set of virtual circuit
features and security attributes associated with the
SVC) configured on the remote system must also be
configured for the NS X.25 system link.
AS/400 Configuration: The NETADDR parameter in the
line description must match this field; see Table 2-8.
X.25 System Access Configuration: The facility set that
the SNA/X.25 SVC will use must be configured for the
NS X.25 system link. If you followed our
recommendation and reserved the facility set for the