SNA Link/iX Node Managers Guide (30291-90009)
Table Of Contents
- 1 SNA Links Overview
- 2 SNA Node and Link Configuration
- 3 Logging Configuration
- 4 SNA Node Startup and Shutdown
- 5 SNA Link Troubleshooting
- 6 MPE Commands
- 7 SNA Link Installation Information
- A Messages
- SDLC Link Startup Error Messages
- SDLC Link Driver Error Messages
- SNACONTROL Error Messages
- SNA Transport Error Messages
- SNA Transport Logging Messages
- SDLC Link Shutdown Error Messages
- X.25 Link Failure Error Codes
- X.25 Link Module Configurator Error Codes
- X.25 Link QLLC Internal Error Codes
- NetView Alerts Error Messages
- Network Dump Manager Error Messages
- LAN Error Messages
- B Netview Alerts

262 AppendixA
Messages
LAN Error Messages
ACTION: Your Hewlett-Packard representative must run diagnostics on
the LAN/console card.
77 MESSAGE: The NIO LAN/console card detects a severe internal error.
CAUSE: Unknown. Need more information.
ACTION: Write down the error information displayed on the console and
call your Hewlett-Packard support contact.
78 MESSAGE: The NIO LAN/console card detects a fatal error in the bus
protocol.
CAUSE: Unknown. Need more information.
ACTION: Write down the error information displayed on the console and
call your Hewlett-Packard support contact.
79 MESSAGE: The NIO LAN/console card reports that the selftest failed.
CAUSE: Unknown. Need more information.
ACTION: Your Hewlett-Packard representative must run diagnostics on
the LAN/console card.
80 MESSAGE: The NIO/LAN console card detected an internal error.
CAUSE: Unknown. Need more information.
ACTION: Write down the error information displayed on the console and
call your Hewlett-Packard support contact.
81 MESSAGE: The NIO/LAN console card detected an internal error.
CAUSE: Unknown. Need more information.
ACTION: Write down the error information displayed on the console and
call your Hewlett-Packard support contact.
82 MESSAGE: The NIO/LAN console card detected an internal error.
CAUSE: Unknown. Need more information.
ACTION: Write down the error information displayed on the console and
call your Hewlett-Packard support contact.
83 MESSAGE: The BDMARS transferred less DMA data than the host
CCMD_IN or CCMD_OUT count requested.
CAUSE: The NIO LAN/console card did not have enough data bytes to
completely fill the inbound buffer. Or the NIO/LAN console card did not
accept all the data that the host tried to send; for example, the number
of bytes were bigger than maximum LAN packet size.
ACTION: Write down the error information displayed on the console and
call your Hewlett-Packard support contact.