SNA Link/iX Node Managers Guide (30291-90009)
Table Of Contents
- 1 SNA Links Overview
- 2 SNA Node and Link Configuration
- 3 Logging Configuration
- 4 SNA Node Startup and Shutdown
- 5 SNA Link Troubleshooting
- 6 MPE Commands
- 7 SNA Link Installation Information
- A Messages
- SDLC Link Startup Error Messages
- SDLC Link Driver Error Messages
- SNACONTROL Error Messages
- SNA Transport Error Messages
- SNA Transport Logging Messages
- SDLC Link Shutdown Error Messages
- X.25 Link Failure Error Codes
- X.25 Link Module Configurator Error Codes
- X.25 Link QLLC Internal Error Codes
- NetView Alerts Error Messages
- Network Dump Manager Error Messages
- LAN Error Messages
- B Netview Alerts

234 AppendixA
Messages
SDLC Link Shutdown Error Messages
SDLC Link Shutdown Error Messages
Listed below are the messages that might occur when you are stopping
the SDLC link. These messages occur when the SNACONTROL STOP
command calls the WAN_Kill_Module procedure and encounters an
error. Depending on the logging configuration for the SDLC Link
subsystem, these messages are logged to the console, to disk, or both.
The messages are logged in this format:
Linkname =
LinkName
Event Type =
EventType
Log Class =
LogClass
Path =
Path
Error Num =
ErrorNumber
Status =
Status
(Note that
LinkName
is the same as the name of the node.) The
messages are listed below in numerical order according to
ErrorNumber
.
51 MESSAGE: Could not stop trace.
CAUSE: Tracing might have been turned off with the SNACONTROL
TRACEOFF command, but the link software status indicates that it is on.
ACTION: Ignore this problem unless you are experiencing other
problems. If you are, write down the error information displayed on the
console and call your Hewlett-Packard support contact.
52 MESSAGE: The link is not in the link table.
CAUSE: The node specified in the SNACONTROL STOP command is not
active.
ACTION: Unless the specified
NodeName
parameter is not correct, no
action is required: The link has already been shut down.
53 MESSAGE: The link type is not SDLC, LAP-B or RJE.
CAUSE: The caller of this module did not set the link type to SDLC,
LAP-B, or RJE BSC. Since you are using an SDLC link, the link type
must be set to SDLC.
ACTION: Write down the error information displayed on the console and
call your Hewlett-Packard support contact.
54 MESSAGE: Could not delete the link from the link table.
CAUSE: The
NodeName
specified in the SNACONTROL STOP command is
not in the link table.
ACTION: Ensure that the
NodeName
is correct and try again. The link
might have already been shut down.
55 MESSAGE: Could not unconfigure the link from the system.
CAUSE: The I/O subsystem does not have any record of this link being
active.