SNA Link/iX Node Managers Guide (30291-90009)

Appendix A 225
Messages
SNA Transport Logging Messages
CAUSE: SNA Transport received an error from the SDLC link driver
because it received a busy signal or no answer at all from the remote
system.
ACTION: This should be a temporary problem. Wait a few minutes and
then try re-dialing.
MESSAGE: NETVIEW ALERT — Inoperative dialing device on node
NodeName
CAUSE: SNA Transport received an error from the SDLC link driver
because it detected that the automatic calling unit (ACU) is not on or
that the cable is missing.
ACTION: Ensure that the ACU is on and functional, and that the cable
is connected correctly.
MESSAGE: NETVIEW ALERT — Link Failure on node
NodeName
CAUSE: SNA Transport received an error from the SDLC link driver
because it detected a link failure.
ACTION: Call your Hewlett-Packard support contact.
MESSAGE: NETVIEW ALERT — WAN driver detected an error on node
NodeName
CAUSE: SNA Transport received an error from the SDLC link driver
because it detected an internal error.
ACTION: Call your Hewlett-Packard support contact.
MESSAGE: (NO DIAGNOSTIC MESSAGE IN CATALOG)
CAUSE: This message is printed for error codes that do not yet have
accompanying diagnostic messages.
ACTION: None; this is a normal event.
MESSAGE: Node
NodeName all sessions closed — beginning
shutdown
CAUSE: SNA Transport has finished shutting down all sessions on the
indicated node and is about to begin node clean up and link shutdown.
ACTION: None; this is a normal event.
MESSAGE: Node
NodeName ready for activation by host
CAUSE: SNA Transport has completed initialization and link activation,
and is now awaiting activation of the PU by the remote system.
ACTION: None; this is a normal event. Note that if you are using a
manual-dial modem, you can begin to dial after this message is
displayed.