SNA Link/iX Node Managers Guide (30291-90009)

Appendix A 213
Messages
SNA Transport Error Messages
SNA Transport Error Messages
Listed below are the error messages that can occur when SNA
Transport intrinsics are being used. They are listed in numerical order
according to message number. SNA Transport, itself, does not display
these messages: It returns the error number to the SNA service using
the intrinsics, and the service can optionally display the message.
These messages are not logged; they are written to $STDLIST by the
SNA service only.
SNAERR 2 MESSAGE: Invalid session. (SNAERR 2) A call was made to an SNA
Transport intrinsic with a bad session number.
CAUSE: An invalid session number was specified in a call to an SNA
Transport intrinsic.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNAERR 3 MESSAGE: Missing Completer Parameter. (SNAERR 3) An SNA
Transport completion occurred with a missing parameter.
CAUSE: The SNA completer was activated with an invalid
Cstation ,
Xfercount , or TargetFlag parameter.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNAERR 5 MESSAGE: Parameter bounds violation. (SNAERR 5) An
out-of-bounds parameter was passed to an SNA Transport intrinsic.
CAUSE: An SNA service passed an out-of-bounds parameter to an SNA
Transport intrinsic.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNAERR 6 MESSAGE: Invalid flag parameter. (SNAERR 6) An invalid flag
parameter was passed to an SNA Transport intrinsic.
CAUSE: The
Flag parameter passed to the SNARcv or SNAPreview
intrinsic was invalid.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNAERR 7 MESSAGE: Session is active. (SNAERR 7) The LU-SSCP session for
this NAU is active.
CAUSE: The NAU’s LU-SSCP session is active.
ACTION: None.