SNA Link/iX Node Managers Guide (30291-90009)

206 AppendixA
Messages
SNACONTROL Error Messages
STOPSESS, SNACONTROL TRACEOFF, SNACONTROL TRACEON, or
SNACONTROL VERSION command. None of these commands uses
LINK=ALL .
ACTION: Reissue the command without a
LINK=ALL parameter.
SNACIERR 67 MESSAGE: CAN’T SPECIFY “LINK=CONF” HERE. (SNACIERR 67)
CAUSE: The
LINK=CONF parameter was specified in an SNACONTROL
AUTODIAL, SNACONTROL START, SNACONTROL STOP, SNACONTROL
STOPSESS, SNACONTROL TRACEOFF, SNACONTROL TRACEON, or
SNACONTROL VERSION command. None of these commands uses
LINK=CONF .
ACTION: Reissue the command without a
LINK=CONF parameter.
SNACIERR 68 MESSAGE: CAN’T SPECIFY “LINK=LINK” HERE. (SNACIERR 68)
CAUSE: The
LINK=LINK parameter was specified in an SNACONTROL
AUTODIAL, SNACONTROL START, SNACONTROL STOP, SNACONTROL
STOPSESS, SNACONTROL TRACEOFF, SNACONTROL TRACEON, or
SNACONTROL VERSION command. None of these commands uses
LINK=LINK .
ACTION: Reissue the command without a
LINK=LINK parameter.
SNACIERR 69 MESSAGE: CAN’T SPECIFY “LINK=STAT” HERE. (SNACIERR 69)
CAUSE: The
LINK=STAT parameter was specified in an SNACONTROL
AUTODIAL, SNACONTROL START, SNACONTROL STOP, SNACONTROL
STOPSESS, SNACONTROL TRACEOFF, SNACONTROL TRACEON, or
SNACONTROL VERSION command. None of these commands uses
LINK=STAT .
ACTION: Reissue the command without a
LINK=STAT parameter.
SNACIERR 70 MESSAGE: CAN’T SPECIFY “LINK=DIAG” HERE. (SNACIERR 70)
CAUSE: The
LINK=DIAG parameter was specified in an SNACONTROL
AUTODIAL, SNACONTROL START, SNACONTROL STOP, SNACONTROL
STOPSESS, SNACONTROL TRACEOFF, SNACONTROL TRACEON, or
SNACONTROL VERSION command. None of these commands uses
LINK=DIAG .
ACTION: Reissue the command without a
LINK=DIAG parameter.
SNACIERR 71 MESSAGE: CAN’T SPECIFY “LINK=RESET” HERE. (SNACIERR 71)
CAUSE: The
LINK=RESET parameter was specified in an SNACONTROL
AUTODIAL, SNACONTROL START, SNACONTROL STOP, SNACONTROL
STOPSESS, SNACONTROL TRACEOFF, SNACONTROL TRACEON, or
SNACONTROL VERSION command. None of these commands uses
LINK=RESET .
ACTION: Reissue the command without a
LINK=RESET parameter.