SNA Link/iX Node Managers Guide (30291-90009)

174 AppendixA
Messages
Link connect failure on node NodeName
subsystem = SubsysID , procedure = ProcNum , error num = ErrorNum
Link failure, recovery in progress on node NodeName
subsystem = SubsysID , procedure = ProcNum , error num = ErrorNum
Link failure, shutting down the node NodeName
subsystem = SubsysID , procedure = ProcNum , error num = ErrorNum
• X.25 link module configurator error codes: These are codes that are
generated by the X.25 link module configurator. They are applicable
based on the
ErrorCode displayed as part of these SNA Transport
logging messages:
Attempt to close link failed on node NodeName
Subsystem = 734, Error Code = ErrorCode
Attempt to open link failed on node NodeName
Subsystem = 734, Error Code = ErrorCode
• X.25 link QLLC internal error codes: These are codes that are
generated by the X.25 link Qualified Logical Link Control (QLLC)
module when a QLLC internal error occurs. They are applicable
based on the
ProcNum displayed as part of these SNA Transport
logging messages:
Link connect failure on node NodeName
subsystem = SubsysID , procedure = ProcNum , error num = ErrorNum
Link failure, recovery in progress on node NodeName
subsystem = SubsysID , procedure = ProcNum , error num = ErrorNum
Link failure, shutting down the node NodeName
subsystem = SubsysID , procedure = ProcNum , error num = ErrorNum
• NetView alerts error messages: These are the error messages that
can occur when an operator-generated NetView alert is sent.
• Network Dump Manager error messages: These are error messages
that are generated when errors occur while the SDLC link is being
dumped. Each message has this prefix:
**** DUMP ERROR
• Token Ring LAN error messages: These are messages generated by
the token ring driver or token ring card. Messages have the following
format:
Internal driver error in SYSLINK (LANWARN ####) or
(LANERR ####)
where #### is an error number.