SNA Link/iX Node Managers Guide (30291-90009)

Appendix A 173
Messages
A Messages
This appendix contains messages that are unique to SNA link activity.
These messages are described:
• SDLC link startup error messages: These are messages that can
occur when you start the SDLC link. These messages occur when the
SNACONTROL START command calls the WAN_Module_Config
procedure and encounters an error. They are logged in this format:
Linkname = LinkName Event Type = EventType
Log Class = LogClass Path = Path
Error Num = ErrorNumber Status = Status
• SDLC link driver error messages: These are messages that are
generated when errors are encountered by the SDLC link driver.
They are logged in this format:
Linkname = LinkName Event Type = EventType
Log Class = LogClass Location = Location
Sublocation = Sublocation Error Code = ErrorCode
State = State Cause Status = CauseStatus
Error Actions = ErrorActions
• SNACONTROL error messages: These are error messages generated by
SNACONTROL commands. Each message has this suffix:
SNACIERR
• SNA Transport error messages: These are run-time error messages
that can occur when SNA Transport intrinsics are used. Each
message has this suffix:
SNAERR
• SNA Transport logging messages: These are messages that are
logged for SNA Transport.
• SDLC link shutdown error messages: These are messages that can
occur when you stop the SDLC link. These messages occur when the
SNACONTROL STOP command calls the WAN_Kill_Module procedure
and encounters an error. They are logged in this format:
Linkname = LinkName Event Type = EventType
Log Class = LogClass Path = Path
Error Num = ErrorNumber Status = Status
• X.25 link failure error codes: These are codes that are generated for
X.25 link failures by the Qualified Logical Link Control (QLLC)
module. They are applicable based on the
ErrorNum displayed as
part of these SNA Transport logging messages: