Read Before Installing MPE/iX PowerPatch 1 Based on Release 6.5 (30216-90319)

Chapter 1 15
Information You Need Before Installing MPE/iX 6.5 PowerPatch 1
Patch MPELX33C
UPS Monitor Operating State : Running (PIN = 52)
UPS Monitor Version Number : 8 3 UPS Devices Configured
System Power State : Power is normal. 3 UPS Devices Monitored
Powerfail Recovery Messages : Console only. 3 UPS Devices Allocated
Configuration File Name : UPSCNFGB.PUB.SYS ( Config File Ok )
UPS DEVICES STATUS:
UPS# Ldev# Alloc Init State Power Hardware Status
~~~~ ~~~~~~ ~~~~~ ~~~~ ~~~~~~~~~~~~ ~~~~~~ ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
1 22 Yes Yes Monitoring Normal AC Power Normal
2 101 Yes Yes Monitoring Normal AC Power Normal
3 103 Yes Yes Monitoring Normal AC Power Normal
End display of UPS Monitor status.
UPSUTIL: Command >
Example #3 - Error in Configuration File
The final example shows what happens when an error is detected in a UPS Monitor
configuration file. In this case, the configuration file UPSCNFGC.PUB.SYS was
attempting to set the powerfail message routing to "all terminals", but there was a
typographic error in the "all terminals" parameter. The UPS Monitor reports the error to
the system console, and the UPSUTIL status command shows that the UPS Monitor has
found an error in the current configuration file, UPSCNFGC.
UPSUTIL: Command > newconfig
Begin SET NEW CONFIG FILE UPS Monitor operation
Enter the file name of the new configuration file (file.group.account)
New config file name? upscnfgc.pub.sys
12:09/52/Illegal configuration command parameter in UPS Monitor
configuration file "UPSCNFGC.PUB.SYS" at record 2, column 29. (UPSERR 0640)
SET NEW CONFIG FILE UPS Monitor operation successfully initiated.
End SET NEW CONFIG FILE UPS Monitor operation
UPSUTIL: Command > status