Read Before Installing MPE/iX PowerPatch 1 Based on Release 6.5 (30216-90319)

14 Chapter1
Information You Need Before Installing MPE/iX 6.5 PowerPatch 1
Patch MPELX33C
Begin display of UPS Monitor status.
UPS MONITOR PROCESS STATUS:
UPS Monitor Operating State : Running (PIN = 52)
UPS Monitor Version Number : 8 3 UPS Devices Configured
System Power State : Power is normal. 3 UPS Devices Monitored
Powerfail Recovery Messages : All terminals. 3 UPS Devices Allocated
Configuration File Name : UPSCNFIG.PUB.SYS ( Config File Ok )
UPS DEVICES STATUS:
UPS# Ldev# Alloc Init State Power Hardware Status
~~~~ ~~~~~~ ~~~~~ ~~~~ ~~~~~~~~~~~~ ~~~~~~~~~~~~~~~~~~~~~~
1 22 Yes Yes Monitoring Normal AC Power Normal
2 101 Yes Yes Monitoring Normal AC Power Normal
3 103 Yes Yes Monitoring Normal AC Power Normal
End display of UPS Monitor status.
UPSUTIL: Command >
Example #2 - Using UPSCNFGB.PUB.SYS
The next example shows the selection of a new UPS Monitor configuration file,
UPSCNFGB.PUB.SYS, in which the powerfail message routing option is set to "console
only". Again, the status command shows the results. UPSUTIL: Command > newconfig
Begin SET NEW CONFIG FILE UPS Monitor operation
Enter the file name of the new configuration file (file.group.account)
New config file name? upscnfgb.pub.sys
SET NEW CONFIG FILE UPS Monitor operation successfully initiated.
End SET NEW CONFIG FILE UPS Monitor operation
UPSUTIL: Command > status
Begin display of UPS Monitor status.
UPS MONITOR PROCESS STATUS: