NS3000/iX Operations and Maintenance Reference Manual (36922-90039)

166 Chapter7
Commands
NSCONTROL STOP
Example 1
Example 1 shows NSCONTROL STOP without the service list. All
Network Services are stopped. Any active servers are allowed to
continue until finished with the current task, at which point they are
terminated. No new service requests are accepted. When all the servers
and services are stopped, the DSDAD process terminates. In the
example, an NSCONTROL ABORT command is issued after the
NSCONTROL STOP command to make sure all Network Services activity
is stopped.
:NSCONTROL STOP {users and servers allowed to finish}
:NSCONTROL ABORT {terminates all network services activity}
:NETCONTROL STOP {terminates all network transport activity}
Example 2
The NSCONTROL STOP=VT,VTA,VTR command shown in the following
example stops the VT, VTA, and Reverse VT services. This prevents
remote users from logging on to the local node using REMOTE HELLO
and from opening local terminals using Reverse VT. If there are any
other active Network Services, they remain available.
:NSCONTROL STOP=VT,VTA,VTR