NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 6 85
Virtual Terminal (VT ERROR) Error Messages
ACTION: Try the remote request later.
MESSAGE: VT TERMINATED, COULD NOT FOPEN TERMINAL.
51 CAUSE: A File System error has occurred; the terminal was not
accessible by the VT program.
ACTION: Save the Node Management logfile, and if the problem recurs,
see Appendix A, “Submitting an SR,” of this manual.
MESSAGE: VT TERMINATED, INVALID DEVICE FOR SESSION.
52 CAUSE: Your session device is not an acceptable MPE session device.
ACTION: Verify the configuration in SYSGEN.
MESSAGE: NO DEVICE STRING SPECIFIED FOR REVERSE-VT.
53 CAUSE: The device string was omitted in the FOPEN or file equation.
ACTION: Insert a device string.
MESSAGE: INVALID TERMINALL SPEED FOR REVERSE-VT.
54 CAUSE: The terminal did not respond since the speed in the
configuration file and the hardware-configured speed do not match.
ACTION: Set the hardware to the speed in the configuration file.
MESSAGE: LOCAL NS GOING DOWN, CONNECTION FAILED.
55 CAUSE:
The connection to the remote machine failed because the local
network services are going down.
ACTION: See Appendix A, “Submitting an SR,” to this manual.
MESSAGE: ATTEMPT TO SET OR STEAL BREAK FAILED.
57 CAUSE: An error occurred while VT trying to set or steal break for the
remote session.
ACTION: Bring up the network services on the local node, and
re-establish the connection.
MESSAGE: SET QUIESE IOQ FAILED.
58 CAUSE: The ATTACHIO failed with an abnormal completion code.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: SET $BACK ENVIRONMENT INFO FAILED.
59 CAUSE: Could not set the $BACK information to environment table.
ACTION: Close the DSLINE, re-open the line, and then initiate a new
remote session.