NS3000/iX Error Messages Reference Manual (36923-90041)

82 Chapter6
Virtual Terminal (VT ERROR) Error Messages
MESSAGE: SET DRIVER MODE FAILED.
25 CAUSE: The File System did not alter the setting of the driver/terminal
handshake mode.
ACTION: Terminate the remote program.
MESSAGE: TERMINAL NOT ALLOCATED.
26 CAUSE: The terminal could not be allocated for access.
ACTION: Check the MPE configuration and retry the remote session.
MESSAGE: SET TERMINAL TYPE FAILED.
27 CAUSE: The terminal type was not reset as requested.
ACTION: Terminate the remote program and rerun it.
MESSAGE: TERMINAL PARITY NOT ALTERED.
28 CAUSE: The parity setting for reads/writes to the terminal was not
altered.
ACTION: Terminate the remote program, check the terminal's
configuration, and rerun the program.
MESSAGE: TERMINAL OPEN FAILED.
29 CAUSE: The terminal could not be opened for VT access.
ACTION: Use SYSDUMP to verify that your terminal is correctly
configured as a valid MPE terminal.
MESSAGE: END OF FILE ENCOUNTERED.
30 CAUSE: A hardware EOF was set on the terminal.
ACTION: Reestablish your local session.
MESSAGE: FATAL INTERNAL ERROR OCCURRED.
31 CAUSE: The VT could not continue because of a VTS protocol error or a
corrupt data structure.
ACTION: Verify the NS version numbers, and if they are compatible,
see Appendix A, “Submitting an SR,” of this manual.
MESSAGE: REMOTE SESSION LOGON FAILED.
32 CAUSE: The remote logon was started; however, it did not succeed
because the logon timed out, a break was issued during logon, the
remote CI aborted, or communication to the remote system was lost.
ACTION: Reattempt the remote logon.
MESSAGE: REMOTE SESSION ABORTED.
33 CAUSE: Some action on the remote system, probably an operator
command, forced the session to be aborted.