NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 6 81
Virtual Terminal (VT ERROR) Error Messages
MESSAGE: CR/LF SWITCH FAILED.
16 CAUSE: The File System did not honor the request to alter the issuing
of Line Feed on receipt of a Carriage Return.
ACTION: This may affect the actions of the remote application program:
if problems occur, reestablish the remote session.
MESSAGE: SET READ TIMEOUT FAILED.
17 CAUSE: Setting of a timed read failed.
ACTION: This may affect the actions of the remote application program:
if problems occur, reestablish the remote session.
MESSAGE: SET ECHO FAILED.
18 CAUSE: The echo setting was not altered as requested by the
application program.
ACTION: This will affect the remote program: terminate and rerun the
program.
MESSAGE: SET PRE/P0ST SPACE FAILED.
19 CAUSE: Space control was not altered.
ACTION: Line feeds will not be issued as requested: rerun the remote
program.
MESSAGE: PREEMPTIVE WRITE.
20 CAUSE: A preemptive write could not be issued.
ACTION: None.
MESSAGE: FWRITE TO TERMINAL FAILED.
21 CAUSE: Data could not be written to the terminal.
ACTION: Reconfigure the terminal to respond to the attached CPU.
MESSAGE: GET TERM-TYPE FAILED.
22 CAUSE: Terminal type could not be retrieved from the file system.
ACTION: Reattempt to establish the remote session. If it fails again,
make sure that the terminal is properly configured for MPE.
MESSAGE: SET EOR FAILED.
23 CAUSE: End-of-Record setting failed.
ACTION: Terminate the remote program, reset the terminal, and run
the program again.
MESSAGE: SET EDIT MODE FAILED.
24 CAUSE: The mode required by the remote program was not set by MPE.
ACTION: Terminate the remote program and attempt to rerun it.