NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 6 79
Virtual Terminal (VT ERROR) Error Messages
6 Virtual Terminal (VT ERROR)
Error Messages
MESSAGE: RESOURCE NOT RELEASED ON TERMINATION.
1 CAUSE: During the termination process a resource was not released
with a good disposition.
ACTION: None; this is not a severe problem since MPE forces cleanup
upon process termination.
MESSAGE: INVALID STATUS FOUND.
2 CAUSE:
Conflicting states existed in the VT status mask. The transition to a
new state could not be made.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: ILLEGAL STATUS STATE.
3 CAUSE: A VT routine requested an illegal option for altering the
current state.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: VTS MESSAGE DOES NOT INCLUDE PARAMTERS.
4 CAUSE: The VTS protocol message has no request parameters. This
may be an error in the data transmission or a mismatch in versions of
the VT software.
ACTION: Verify the VT versions on the different nodes, retry the VT
session, and/or see Appendix A, “Submitting an SR,” of this manual.
MESSAGE: VTS MESSAGE CONTAINS AN INVALID PARAMETER.
5 CAUSE: The VTS protocol message contains an invalid request. This
may be a transmission error or a result of incompatible versions of VT.
ACTION: Check the VT version numbers using NMMAINT, retry the
VT session. If the problem recurs, see Appendix A, “Submitting an SR,”
of this manual.
MESSAGE: VTS MESSAGE HAS INVALID FORMAT.
6 CAUSE: The VTS protocol message could not be decoded; the format
was not recognized. This results from incompatible versions of the
software or an uncorrected transmission error.
ACTION: Verify the VT software version numbers, retry the VT session.
If the problem recurs, see Appendix A, “Submitting an SR,” of this
manual.