NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 5 75
NetIPC (SOCKERRS) Error Messages
ACTION: Check the values being placed in the opt record.
MESSAGE: RESET EVENT OCCURRED ON X.25 CONNECTION.
146 CAUSE: An unsolicited reset packet was received.
ACTION: Use IPCCONTROL (request 12) to examine the
cause/diagnostic field. The connection is still up and operational but
some data may have been lost.
MESSAGE: COULD NOT OBTAIN A SEMAPHORE.
151 CAUSE: The attempt to obtain a semaphore before sending a message
to the protocol module failed.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: SOCKET IS ALREADY IN USE.
153 CAUSE: A single socket per network interface can be created with the
catch-all capability.
ACTION: Wait for catch-all socket to be released.
MESSAGE: INVALID X.25 FLAGS OPT RECORD ENTRY.
155 CAUSE: Invalid flag bits set in protocol specific flags option, or invalid
length specified for option, or user did not have NA capability.
ACTION: Check bits set and length specified. Bit numbering is from left
to right (0–31).
MESSAGE: INTERRUPT EVENT OCCURRED ON X.25 CONNECTION.
156 CAUSE: An unsolicited interrupt packet was received.
ACTION: Use IPCCONTROL (request 12) to get interrupt data. The
connection is still up and operational.
MESSAGE: NO VIRTUAL CIRCUIT CONFIGURED.
157 CAUSE: No VC configured in the configuration file.
ACTION: Check the configuration file for X.25.
MESSAGE: CONNECTION REQUEST REJECTED BY REMOTE.
158 CAUSE: The remote node received the connection request and rejected
it.
ACTION: The call may be retried later. Otherwise, the reason for the
reject must be known.
MESSAGE: INVALID X.25 D BIT SETTING.
159 CAUSE: The D bit setting is not consistent in configuration file of local
and destination node.
ACTION: Check the configuration file for X.25.