NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 5 73
NetIPC (SOCKERRS) Error Messages
MESSAGE: INVALID SOFTWARE INTERRUPT PROCEDURE LABEL.
113 CAUSE: Procedure label passed when enabling software interrupts is
invalid.
ACTION: Check the PLABEL you are passing.
MESSAGE: CREATION OF SOCKET REGISTRY PROCESS FAILED.
114 CAUSE: Socket registry program missing.
ACTION: Contact your Hewlett-Packard representative for assistance.
MESSAGE: DESTINATION UNREACHABLE.
116 CAUSE: The transport was unable to route the packet to the
destination.
ACTION: Notify your operator.
MESSAGE: ATTEMPT TO ESTABLISH CONNECITON FAILED.
117 CAUSE: Protocol module was unable to set up the requested connection.
This may be caused by the remote protocol module not being active.
ACTION: Notify your operator.
MESSAGE: INCOMPATIBLE VERSION.
118 CAUSE: NetIPC software was incompatible with the software being
executed by the remote registry process.
ACTION: Notify your operator.
MESSAGE: INCOMPATIBLE VERSION.
119 CAUSE: An unsupported option was specified in the opt record, or a
nonprivileged user attempted to specify a privileged option.
ACTION: Check your opt record and remove or modify the option.
MESSAGE: ERROR IN WINDOW UPDATE THRESHOLD OPTION.
120 CAUSE: An unsupported option was specified in the opt record, or a
nonprivileged user attempted to specify a privileged option.
ACTION: Check your opt record and remove or modify the option.
MESSAGE: ERROR IN WINDOW UPDATE THRESHOLD OPTION.
124 CAUSE: User error. Entry number of option is either negative or higher
than specified in INITOPT value.
ACTION: Correct and reissue command.
MESSAGE: INVALID OPTION DATA LENGTH.
125 CAUSE: User error. Data length for option is either negative or higher
than specified in INITOPT value.
ACTION: Correct and reissue command.