NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 4 57
NFT/3000 Error Messages
MESSAGE: UNABLE TO OBTAIN INFO ON NEWLY CREATED
SESSION.
91 CAUSE: Probable internal error.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: INVALID STRING FOLLOWING RIGHT BRACKET.
92 CAUSE: One or more invalid characters follow the right bracket in the
logon part of the DSCOPY command.
ACTION: Re-enter the command using the correct delimiters.
MESSAGE: INVALID STRING FOLLOWING CLOSING QUOTE.
93 CAUSE: One or more invalid characters follow a closing quote. A file
name, node name, or logon name enclosed in quotes must be followed by
an appropriate delimiter.
ACTION: Re-enter the DSCOPY command using correct delimiters.
MESSAGE: BOUNDS VIOLATION
94 CAUSE: Internal error parameter out of bounds.
ACTION: Check parameters passed to DSCOPY or DSCOPY
MSG.
MESSAGE: SPLITSTACK MODE CALLS NOT ALLOWED.
95 CAUSE: DSCOPY will not run in splitstack mode.
ACTION: Do not attempt to run DSCOPY in splitstack mode.
MESSAGE: FIRST PARAMETER IS OUT OF RANGE (0:14).
96 CAUSE: OPT has value other than 0 opt 14.
ACTION: Check content of OPT parameter.
MESSAGE: ILLEGAL BASIC CALLING SEQUENCE.
100 CAUSE: There is in an error in the calling sequence of a BDSCOPY
intrinsic call.
ACTION: Refer to Using NS 3000/iX Network Services for the correct
calling sequence.
MESSAGE: AUTOLOGON DISABLED; USE :REMOTE HELLO FOR
REMOTE SESSION.
103 CAUSE: Automatic logon facility has been turned off by the network
manager.
ACTION: Logon to the remote environment using the REMOTE
HELLO command. Specify this remote environment in the DSCOPY
command.