NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 19 563
Logging Location Codes
X.25 Logging Location Codes
MESSAGE: Internal Error.
209 CLAS0002 CAUSE: A Buffer could not be obtained from the control buffer pool
(PARM = status from Bmgr_get_buffer).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
210 CLAS0002 CAUSE: Reading the configuration buffer failed on a Netcontrol
Update (PARM = status and length).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
211 CLAS0002 CAUSE: There are more facility sets in the configuration file than
allowed (PARM = number of facility sets).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
212 CLAS0002 CAUSE: An error occurred while reading a facility set from the
configuration file (PARM = length).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: Internal Error.
213 CLAS0002 CAUSE: An escape occurred inside X.25 (PARM = escape code).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
214 CLAS0005 CAUSE: An N-Disconnect packet was sent because a message arrived
that was greater than 30 kilobytes (PARM = Device ID, VC number,
cause, diagnostic).
ACTION: Change the remote application to send less than 30 kilobytes
of data at a time.
MESSAGE: Internal Error.
215 CLAS0002 CAUSE: Netfc_create_pool failed right after a
Netfc_delete_pool (PARM = status from Netfc_create_pool).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: Internal Error.
216 CLAS0002 CAUSE: Netfc_delete_pool failed on expedited semaphore pool
(PARM = status from Netfc_delete_pool).
ACTION: See Appendix A, “Submitting an SR,” of this manual.