NS3000/iX Error Messages Reference Manual (36923-90041)

560 Chapter19
Logging Location Codes
X.25 Logging Location Codes
ACTION: Try again later, or increase the number of buffers configured.
MESSAGE: None
186 CLAS0005 CAUSE: An outgoing IPC connection request was rejected because the
specified facility set does not exist.
ACTION: Define a new facility set for this configuration, or assign an
existing facility set.
MESSAGE: None
187 CLAS0005 CAUSE: An outgoing IPC connection request was rejected because the
specified Call User Data field is too long.
ACTION: Either decrease the size of the call user data field or use the
fast select facility, or use the “no address” flag.
MESSAGE: None
188 CLAS0005 CAUSE: An outgoing IPC connection request was rejected because the
specified destination node does not have an X.25 address in the
configuration file.
ACTION: Make sure that the SVC path for the destination node in the
configuration file matches the Network Directory. The address keys
must be the same.
MESSAGE: None
189 CLAS0003 CAUSE: An outgoing IPC connection request was rejected because no
outbound buffers are currently available.
ACTION: Try again later, or increase the number of outbound buffers
configured.
MESSAGE: None
190 CLAS0003 CAUSE: A connection cannot be opened because no free semaphore
resources are available to create an expedited semaphore pool. Either
the system is at its limit of 1024 connections, or semaphores were
steadily lost and the supply is exhausted (PARM = status from
Netfc_create_pool).
ACTION: Try again later. If the maximum number of VCs are not open,
submit and SR. Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
191 CLAS0003 CAUSE: A connection cannot be opened because no free semaphore
resources are available to create a regular semaphore pool. Either the
system is at its limit of 1024 connections, or semaphores were steadily
lost and the supply is exhausted (PARM = status from
Netfc_create_pool).
ACTION: Try again later.