NS3000/iX Error Messages Reference Manual (36923-90041)

558 Chapter19
Logging Location Codes
X.25 Logging Location Codes
ACTION: None. This is an informative message. If you want to accept
this call, modify the remote machine so that fast select restriction is not
set.
MESSAGE: None
172 CLAS0005 CAUSE: An incoming connection request was rejected because the IPC
socket with the protocol relative address specified in the call has not
been created (PARM = Device ID, VC number, cause, diagnostic).
ACTION: None. This is an informative message. Check that the
program with this socket address is running.
MESSAGE: None
173 CLAS0005 CAUSE: An incoming connection request was rejected by the IPC user
or application program (PARM = Device ID, VC number, cause,
diagnostic).
ACTION: None. This is an informative message.
MESSAGE: None
174 CLAS0003 CAUSE: An incoming connection request was rejected because there are
no outbound buffers available.
ACTION: Try again later. Or increase the number of buffers configured
and try again.
MESSAGE: None
175 CLAS0005 CAUSE: An outgoing IPC connection request was rejected because the
path report did not contain an IP address that is in the same IP
network as this node.
ACTION: Check the IP addresses of the local and remote nodes. The
network portion of the IP addresses should be the same.
MESSAGE: None
176 CLAS0003 CAUSE: An AFCP connection could not be opened to the DTC. The DTC
card could be fully utilized by another MPE/iX host (PARM = status
from MCM).
ACTION: Try again later.
MESSAGE: None
177 CLAS0005 CAUSE: An outgoing IPC connection request was rejected. The rejection
may have come from the local DTC, the network, or the remote node
(PARM = Device ID, VC number, cause, diagnostic).
ACTION: Check the diagnostic code returned. Verify that all
components are operational.