NS3000/iX Error Messages Reference Manual (36923-90041)

556 Chapter19
Logging Location Codes
X.25 Logging Location Codes
MESSAGE: None
159 CLAS0005 CAUSE: An inbound IPC connection was opened (PARM = Device ID,
VC number).
ACTION: None. This is an informative message.
MESSAGE: None
160 CLAS0005 CAUSE: A connection was closed (PARM = Device ID, VC number).
ACTION: None. This is an informative message.
MESSAGE: None
161 CLAS0003 CAUSE: A connection cannot be opened as X.25 has reached its limit for
the number of connections (PARM = number of connections in use).
ACTION: Close the connections which are no longer being used and try
again.
MESSAGE: None
162 CLAS0003 CAUSE: X.25 is out of outbound buffers.
ACTION: The transport will still work but at a reduced speed and
increased CPU overhead. You might want to increase the number of
outbound buffers configured.
MESSAGE: None
163 CLAS0005 CAUSE: An incoming connection request was rejected because it has
requested reverse charging, and this facility set does not accept reverse
charge calls (PARM = Device ID, VC number, cause, diagnostic).
ACTION: None. This is an informative message. If you want to accept
reverse charge calls, modify the facility set.
MESSAGE: None
164 CLAS0005 CAUSE: An incoming connection request was rejected because it
requested packet size negotiation, and this facility set does not
negotiate packet size (PARM = Device ID, VC number, cause,
diagnostic).
ACTION: None. This is an informative message. If you want to
negotiate packet size, modify the facility set.
MESSAGE: None
165 CLAS0005 CAUSE: An incoming connection request was rejected because it
requested window size negotiation, and this facility set does not
negotiate window size (PARM = Device ID, VC number, cause,
diagnostic).
ACTION: None. This is an informative message. If you want to
negotiate window size, modify the facility set.