NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 19 555
Logging Location Codes
X.25 Logging Location Codes
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
150 CLAS0002 CAUSE: X.25 received an unknown message format (PARM = message
format).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
151 CLAS0002 CAUSE: X.25 received an initialization message from the Control
Process when its port data area was non zero (PARM = control server
state).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
153 CLAS0003 CAUSE: An attempt to open a new socket has failed because the socket
table is full (PARM = number of sockets in use).
ACTION: Close some of the sockets which are no longer useful and try
again.
MESSAGE: None
154 CLAS0005 CAUSE: A socket was opened (PARM = socket’s address).
ACTION: None. This is an informative message.
MESSAGE: None
155 CLAS0005 CAUSE: A socket was closed (PARM = socket’s address).
ACTION: None. This is an informative message.
MESSAGE: None
156 CLAS0004 CAUSE: An operator issued a NETCONTROL STOP command, but there
are sockets or connections currently in use. These sockets are aborted
before X.25 terminates (PARM = number of sockets and connections in
use).
ACTION: None. This is an informative message.
MESSAGE: None
157 CLAS0005 CAUSE: An outbound IPC connection was opened (PARM = Device ID,
VC number).
ACTION: None. This is an informative message.
MESSAGE: None
158 CLAS0005 CAUSE: An inbound TCP/IP connection was opened (PARM = Device
ID, VC number).
ACTION: None. This is an informative message.