NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 19 547
Logging Location Codes
UDP Logging Locations
MESSAGE: None
45 CLAS0003 CAUSE: Failed in attempting to re-obtain a path descriptor on
verification for a socket (PARM = Status returned by
ns_path_resolve).
ACTION: Check the IP address and the network being used. If OK then
see Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
46 CLAS0003 CAUSE: Attempt to get a path descriptor for the destination in the
datagram send request failed (PARM = Result code returned by
ns_path_resolve).
ACTION: Check the IP address of the destination specified in the
IPCSENDTO call. Also make sure the necessary networks are started. If
problems persist then see Appendix A, “Submitting an SR,” of this
manual.
MESSAGE: None
47 CLAS0003 CAUSE: The attempt to resolve a path failed, most likely due to timeout
during address resolution (PARM = Result code returned by MAP in the
path reply).
ACTION: Check the IP address of the destination given in the
IPCSENDTO call. Also make sure the necessary networks are started. If
OK then see Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
48 CLAS0002 CAUSE: Attempt to send the reply to CP for a traceoff message failed
(PARM = Result code returned by send_msg).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
49 CLAS0002 CAUSE: Attempt to send a reply to CP for a path verify message failed
(PARM = Status returned by send_msg).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
50 CLAS0003 CAUSE: Received an inbound ICMP message from IP to be passed to an
application (PARM = ICMP error type and code).
ACTION: Check if application needs to handle this message (i.e., source
quench or destination unreachable).