NS3000/iX Error Messages Reference Manual (36923-90041)

544 Chapter19
Logging Location Codes
UDP Logging Locations
MESSAGE: None
18 CLAS0002 CAUSE: Attempt to write the UDP header into a buffer on an outbound
datagram failed (PARM = Status returned by bmgr_write_buffer).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
19 CLAS0004 CAUSE: Logging the start of the UDP module (PARM = UDP’s port ID).
ACTION: Informative message.
MESSAGE: None
20 CLAS0002 CAUSE: Attempt to add UDP to the ports data dictionary failed (PARM
= Result code from the dict_add call).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
21 CLAS0002 CAUSE: Attempt to delete UDP from the ports MPE CM dictionary
failed (PARM = Result code returned by dict_delete call).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
22 CLAS0002 CAUSE: Attempt to delete UDP from the ports MPE CM dictionary
failed (PAttempt to send the ICMP destination unreachable message to
IP failed (PARM = Result code returned by send_msg).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
23 CLAS0002 CAUSE: Attempt to free an inbound buffer due to a shutdown pending
failed (PARM = Status returned by bmgr_free_buffer).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
24 CLAS0002 CAUSE: Attempt to free an inbound buffer, because there is no more
room in the IPC buffer array, failed (PARM = Result code from
bmgr_free_buffer).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
25 CLAS0004 CAUSE: UDP module stopped.
ACTION: Informative message
MESSAGE: None
26 CLAS0002 CAUSE: Send of IPCControl reply message to NetIPC failed (PARM =
Result code from send_msg).