NS3000/iX Error Messages Reference Manual (36923-90041)

538 Chapter19
Logging Location Codes
TCP Logging Locations
MESSAGE: None
17101 CLAS0005 CAUSE: The user or service (through IPC) has rejected the passive
connection attempt, or an error has occurred on the connection since
the passive open request was received.
ACTION: Informative message. PARM is rejection reason. If PARM is 0,
user/service rejected the connection. Otherwise, an error condition has
been detected by TCP. Look for logging indication of other error on same
connection. (Remember that other logging classes may or may not be
enabled.) Network/nodal shutdown processing may cause this error. If
error is unexplainable, submit an SR.
MESSAGE: None
17201 CLAS0005 CAUSE: TCP connection deactivated due to an error.
ACTION: Informative message. No action required. Error type may be
normal or serious. Find matching error indication for connection and
follow action text. (Remember that all classes of logging may not be
enabled.)
MESSAGE: None
17301 CLAS0003 CAUSE: User or service attempted to create TCP socket which already
exists.
ACTION: Correct program/service in error or close previous socket
incarnation.
MESSAGE: None
17401 CLAS0002 CAUSE: TCP protocol start failed.
ACTION: Submit an SR.
MESSAGE: None
17402 CLAS0002 CAUSE: Bad status returned in message from TCP SIP during a
network startup. The TCP SIP wasn't created.
ACTION: PARM indicates status from message. Look for logging
indication explaining TCP SIP initialization failure. Submit an SR.
MESSAGE: None
17403 CLAS0002 CAUSE: TCP SIP portid was not found.
ACTION: Suspect error in protocol startup or protocol initialization.
Look for logging indication explaining TCP SIP initialization failure.
Submit an SR.
MESSAGE: None
17404 CLAS0002 CAUSE: Error in protocol initialization.
ACTION: Look for logging indication explaining TCP SIP initialization
failure. Submit an SR.