NS3000/iX Error Messages Reference Manual (36923-90041)

536 Chapter19
Logging Location Codes
TCP Logging Locations
MESSAGE: None
16110 CLAS0005 CAUSE: The TCP SIP tossed a packet from a half open connection
because it couldn’t get a route to send an outbound reset.
ACTION: Informative message. No action required. Possibly diagnose
route resolution failure. Likely link/gate/nodal failure or configuration
error.
MESSAGE: None
16111 CLAS0005 CAUSE: The TCP SIP tossed a packet from a half open connection
because it couldn't get a route, after waiting for a reply from paths, to
send an outbound reset.
ACTION: Informative message. No action required. Possibly diagnose
route resolution failure. Likely link/gate/nodal failure or configuration
error.
MESSAGE: None
16112 CLAS0005 CAUSE: The TCP SIP tossed a packet from a half open connection
because it had the reset flag set.
ACTION: Informative message. No action required.
MESSAGE: None
16113 CLAS0005 CAUSE: The TCP SIP tossed a packet because it had the reset flag set
and destination socket was in the listen state.
ACTION: Informative message. No action required.
MESSAGE: None
16201 CLAS0005 CAUSE: The retransmission interval for a packet has expired; however,
a previous transmission of this packet has not yet left the node (or in
loopback has not been released by the receiver).
ACTION: This indicates congestion within the node itself (e.g. the host
running faster than the card can allow). Occasional occurrences are
considered normal. Excessive occurrences (in other than loopback)
indicate a more serious software problem.
MESSAGE: None
16202 CLAS0005 CAUSE: An attempt was made to retransmit a packet in loopback.
ACTION: Repeated occurrences indicated a software problem.
MESSAGE: None
16301 CLAS0005 CAUSE: The retransmission interval for a packet has expired without
receipt of an acknowledgment from the remote connection half.