NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 19 529
Logging Location Codes
TCP Logging Locations
ACTION: Excessive retransmissions indicate a possible route/gate
failure or possible end node failure or possible misconfiguration.
Extreme network bottlenecks may also cause this type of problem
although TCP should be able to adjust to most network conditions. A
temporary work around may be to increase the configured number of
maximum retransmissions. If a direct cause is not found consider
further diagnosis with a line analyzer or submitting an SR.
MESSAGE: None
14101 CLAS0003 CAUSE: The total retransmission time for a packet has exceeded the
configured MAXIMUM TIME TO WAIT FOR REMOTE RESPONSE.
Connection will abort.
ACTION: Excessive retransmission time indicates a possible
route/gate/end node failure or possible misconfiguration. Extreme
network bottlenecks may also cause this type of problem although TCP
should be able to adjust to most network conditions. A temporary work
around may be to increase the MAXIMUM TIME TO WAIT FOR
REMOTE RESPONSE. If a direct cause is not found consider further
diagnosis with a line analyzer or submitting an SR.
MESSAGE: None
14201 CLAS0005 CAUSE: A valid reset packet was received on a connection. The
connection will abort.
ACTION: Informative message. No action required. This message
normally appears because the remote connection half was terminated
abruptly by the user through an abortive IPC shutdown. Many services
use this type of shutdown. Remote abortions also occur when errors are
encountered on the remote system. In unexpected abortion situations
inspection of the remote system for indications of error is suggested.
MESSAGE: None
14202 CLAS0005 CAUSE: A valid reset packet was received on a connection. The
connection will abort.
ACTION: Informative message. No action required. This message
normally appears because the remote connection half was terminated
abruptly by the user through an abortive IPC shutdown. Many services
use this type of shutdown. Remote abortions also occur when errors are
encountered on the remote system. In unexpected abortion situations
inspection of the remote system for indications of error is suggested.
MESSAGE: None
14203 CLAS0005 CAUSE: A valid reset packet was received on a connection. The
connection will abort.
ACTION: Informative message. No action required. This message
normally appears because the remote connection half was terminated
abruptly by the user through an abortive IPC shutdown. Many services